Clear all
When you carry a few spinning sets, the place for their arrangement by the water becomes part of the organization of fishing. Stands, tripods and tongs have a different way of placement, so they must comply with the pitch and number of fishing lines. A well-chosen support keeps sets separate, accessible and arranged when changing between different lures or settings.

Stand for Trout Area fishing DAIWA PRESSO IPRIMI ROD STAND is a lightweight aluminum construction for storing up to three fishing rods in Trout Area fishing. Her telescopic legs are individually adjusted within 39–62 cm. This allows the height of each pivot point to be adjusted according to the location, instead of the entire tripod following one common slope.

See more View less

The stand-alone tripod is suitable when there is no ready pivot point, while the clip suggests a place to which it can be attached. Before choosing, consider how many rods you will actually arrange and whether their handles stand freely next to each other. It is also important that access to each fishing pole remains clear, without the lines and baits crossing.

On a rough shore, do not stretch all telescopic legs equally out of habit. Set the stand, adjust each leg to the slope and press the structure slightly to check if it is shaking. On a soft base, choose an equal section without a crumbly edge; on a hard site make sure that the legs have secure contact and do not stand on free pebbles.

The possibility of three sets is useful when different sets are prepared in advance for consistent use. Arrange them always in a logic, for example in length or order of use, and leave the baits secured. So you take the right fishing rod immediately, without the tips hitting or the hooked lure passing the rest of the lines.

After fishing, wipe the aluminum parts, clean the telescopic joints and put the feet away only after they are dry. Before the next outing, check whether the adjustments hold at the chosen height and whether the supports are stacked. A typical mistake is to overload the stand or put it into a passage; even properly leveled, it must remain off the trail for movement and fish extraction.

If you specify how you will organize the fishing rod during the outing, you can connect the stand to the rest of your spinning tackle by Spinning Fishing. For comparison with arrangement in more stationary fishing look Carp fishing stands, and from there proceed to Rod Pod and stands as another kindred direction.