Clear all
When installing a float, the aggravation determines how the bait goes down, where it is established and how clearly the bites is seen. The section includes single-saw and double-saw pellets, olivettes and probes. The first two groups serve to distribute small weights along the line, the olivettes give concentrated aggravation, and the probe helps to establish depth. These are different solutions, not interchangeable forms of load.

Refill Lead MAVER Slot-eez Refills contains split shot pellets for fine tuning of the tackle. Their slim shape allows for fine-tuning close to the float's load-bearing, and the precise weight and center shear support even placement. Available sizes are 10 and 12, so select according to the actual required adjustment. Practical packaging makes it easy to organize the dimensions around the water. Work step by step without adding a few pellets at a time.

See more View less

The distribution along the line is just as important as the total weight. A more assembled group accelerates the passage through the water layer, while the spaced small pellets change the way the bait falls. Do not add weights arbitrarily: start from the bearing of the float, then adjust gradually and monitor the position of the antenna. After each change, re-run the montage before deciding if the balance is right.

The olive is appropriate when rig requires the main mass to be concentrated in one zone. The pellets leave more room for repositioning and tuning. The probe performs a separate function: with it, you check the bottom and working depth before you finally arrange the aggravation. Do not mix measurement with subsequent line balancing. Thus, each element enters the rig with a clear task.

In calm water, fine adjustment is often evident by the behaviour of the float. In the current, you have to account for both the line pressure and the speed of fall. If you change the float, do not keep the old aggravation out of habit; review the bearing and placement again. Even a small change may require a new balance, especially when the antenna is already standing too low or too high.

When placing, press only as much as needed to keep the pellet in place without unnecessarily damaging the line. If you move it, check the area for deformation. Keep dimensions separate and marked in the box; This speeds up adjustments and reduces the likelihood of putting a different weight inadvertently. After the outing, put the lead away safely, no free pellets among the rest of the accessories.

For clearer line arrangement open Float fishing accessories and weigh the weights against the other float accessories. If you want a wider starting point, see Weights, and for comparison with mounts for other type of fishing look at Carp fishing weights.