Clear all
Ready-made mounts and feeder accessories shorten the preparation, but do not negate the need for each part to be compatible. The section includes ready-made rigs, stoppers, silicone rings, tubes, needles, screws, quick links and feeders type „spring“. Each element occupies a specific place between the main line, feeder, leader and bait. Well-chosen parts facilitate water change, but an inappropriate combination can worsen the arrangement and operation of the entire line at the first controlled cast.

When choosing a feeder rig, start from the system used and the way the components connect. Check the diameter of the line, the size of the connections and the free movement of the movable parts. The stopper should lie down firmly, and the silicone ring, needle or screw match the bait, without forcing and deformation.

See more View less

Set of feeder tubes PRESTON ICS offers two lengths and two degrees of durability of the elastic. The variants are LONG/STANDARD, LONG/HEAVY, SHORT/STANDARD and SHORT/HEAVY. Standard is specified for carp and for small to medium carp. This gives a clear basis for choosing according to length and required strength.

Before assembling, make sure that the tube belongs to the ICS system used and that the remaining parts fit without any gaps or excessive effort. The long and short variant change configuration, so keep the same other parameters in the first comparison. This way you will feel the effect of length without mixing a few changes. Check also that the elastic moves freely without twisting in the assembled position.

Ready feeder rigs are convenient as reserves, as long as you review them before casting. Check the knots, tubes and quick links, then load the line smoothly with your hand. When changing feeder, monitor whether its weight remains appropriate for the rod and conditions. A twisted or frayed part is replaced instead of covered with a stopper.

Store the finished lines unfolded or rolled up on a suitable base, without sharp folds. Divide Standard and Heavy as well as LONG and SHORT, with legible markings. After fishing, clean the glued groundbait and let the silicone parts dry outside the closed box. Good arrangement accelerates the shift and reduces the risk of putting in an unsuitable component.

Start with Feeder Feeders, when you want to match the rig to the feed method. Then compare Ready-made rigs and accessories, if you consider the ready solutions and outside the feeder context. For the rest of the tackle, go back to Fishing accessories and finish the arrangement according to the intended fishing.